Tips for choosing a location

Before excavating the foundation pit, check whether the planned installation site meets the requirements for a separator system by considering the following questions and tips:

• Is the planned area free of utility lines and cables?
• Can access for maintenance, inspection and disposal be guaranteed at all times?
• Can an inspection chamber be installed in front of the separator, e.g. to facilitate the user-friendly insertion of bubbles during a leak test?
• Is the installation site located outside the traffic area? Will the subsequent use of the area be unaffected by the separator system?
• Is the installation site located near the point where the wastewater is generated?
• Are the systems easily accessible to disposal vehicles? Special operating conditions or structural constraints may necessitate a location further away from the points where the wastewater is generated.
• Is the separator system protected against frost damage?
• Are all parts requiring regular maintenance easily accessible at all times?
• Where necessary, covers for separator systems must be supported in such a way that the load on the separator does not exceed its load-bearing capacity. Can this be guaranteed?
• Is there a water connection available for filling and Cleaning the separator system?
• Please note: For load class D up to 40 t, a load distribution plate on site is required. You can obtain the relevant reinforcement plans from us.